JLM Direct Injector Valve Cleaner 500 ml
JLM Direct Injector Valve Cleaner 500 ml
JLM Direct Injector Valve Cleaner is an effective remover of high-temperature baked-on carbon deposits that accumulate especially in engine combustion chambers and behind valves. Specific high-temperature deposits form in gasoline direct injection (GDI) and hybrid engines, but they also plague diesel engines, leading to a loss of power, efficiency and reduced reliability. The easy-to-use spray contains special cleaning surfactants that loosen and remove baked-on carbon more effectively than alternative solvent-only products. As the cleaning solution passes into the engine, the chemical formulation is non-aggressive and harmless to particulate filters and catalytic converters. It cleans not only the valves, but also the entire combustion chamber. This results in increased engine efficiency and reduced exhaust emissions, especially carbon monoxide (CO) and hydrocarbons (HC), with the added benefit of better cold start performance.
Key features of JLM Direct Injector Valve Cleaner, 500ml
- Designed for direct injection petrol and diesel engines
- Suitable for hybrid engines
- Special formulation for high-temperature carbon deposits
- Restores engine efficiency
- Cleans valves, combustion chambers and piston crowns
Cleaner and more efficient engine operation
JLM Direct Injector Valve Cleaner is one of a suite of highly effective products to remove harmful carbon deposits that affect modern engines. For best results, we recommend using the product together with JLM GDI Injector Cleaner additive (petrol engines only) and JLM EGR & Air Intake Cleaner spray (petrol and diesel). JLM designed the Direct Injector Valve Cleaner for simple use. Instead of requiring direct access to the cylinder head intake ports, the product penetrates the air intake of a warm engine, preventing extensive disassembly.
Application:
The product is designed for professional use only.
Shake the aerosol for at least two minutes and direct the spray into the intake in small bursts not exceeding three seconds. Never allow the cleaner to pass through an intercooler or enter corrugated/coiled rubber hoses, which could cause the solution to pool.
1. Start the engine, ensure it is at normal operating temperature and let it idle.2. Spray the product into the intake manifold at short intervals (up to three seconds). The engine speed may increase or decrease with each application. Allow the engine speed to stabilise before spraying again.3. If the engine speed increases or you hear knocking/clicking/clinking, stop spraying and let the engine idle. Do not depress the accelerator pedal.4. After using half the contents of the spray, let the engine idle for another two minutes before continuing.5. After using the spray, let the engine idle for another two minutes.6. Stop the engine and reassemble the intake system.7. Restart the engine and briefly increase the speed to 2500rpm and let it idle again. Repeat 10×. Alternatively, take a short drive of 5–8km. 8. Let the engine idle for at least a minute again before stopping it.9. JLM Direct Injector Valve Cleaner should be used in well-ventilated areas. Wear gloves and eye protection.
Specifications
Volume
Usage
Season
Type
Features
| Code: | MOTO97171 |
| Warranty: | 24 months |
| Manufacturer information |
ACI Auto Components International s.r.o.,Podnikatelská 549, 190 11 Praha 9 - Běchovice, [email protected], www.aci.cz 
|