Sparkly POOL Hardness stabilizer - hardness reduction 3 l

Sparkly POOL hardness stabilizer is a chlorine-free productdesigned to reduce water hardness in all types of pools when using chlorine and chlorine-free chemistry. The hardness of the water in the pool is one of the most important values when treating it. Not only hard pool water, but also soft water contains minerals that cause unsightly deposits on the walls over time. Adjusting the hardness of the pool water with this softener reliably prevents the formation of these deposits. It is recommended to adjust, reduce the hardness of the water in the pool immediately after filling it. Sparkly POOL Hardness Stabilizer is designed for fresh and salt water pools and hot tubs.

Dosing:
To reduce water hardness by 1 °N, apply 60 ml of the product for every 1 m³ (1000 l) of pool water volume. A reduction in water hardness (measurable difference) will not occur until 7 days after application of this product or after use of one of the flake products. Use this product safely. Always read the information on the packaging before use.
The active ingredient of this product ensures the conversion of insoluble compounds into soluble ones, which can cause milky turbidity if the water used to fill the pool contains excessive amounts of calcium. In the event that the water becomes cloudy after application of this product, leave the product to act in this way for at least 7 days and then use a FLOORER, EXTRA FLOORER or EXTRA PROJASTER (from the Sparkly POOL range) to remove the clouding according to the instructions on their packaging. After floatation, the removed limescale from the pool water can be seen at the bottom of the pool, which must necessarily be sucked into the waste outside the filtering device.
Note:
Do not mix or use with other products, especially strong oxidizing agents and strong bases. The product may only be used for water treatment in swimming pools. The manufacturer is not liable for any damage caused by improper use of the product.
DESCRIPTION OF FIRST AID:
WHEN INHALED:
Interrupt exposure, transport the victim to fresh air. If nausea persists, arrange for medical attention.
When in contact with the skin:
Remove contaminated clothing, shoes and wash thoroughly with water (preferably lukewarm) and soap. Do not use solvents or thinners. If the trouble persists, seek medical attention.
FOR CONTACT WITH THE EYE:
Rinse with a gentle stream of water for at least 15 minutes. Keep the eyelids wide open with your thumb and forefinger. If the affected person wears contact lenses, remove them before flushing the eyes if this is easy. Seek professional medical treatment.
FOR FOOD:
Rinse your mouth and drink plenty of water. Do not induce vomiting. Do not serve milk or alcoholic beverages. Never give anything by mouth to an unconscious person. Seek medical attention.
LIKVIDATION:
Remove according to applicable Czech and local regulations (e.g. in a hazardous waste incinerator). Never dispose of by flushing down the drain. Do not contaminate standing or running water with chemicals or used containers. Pass residual quantities and unreclaimed solutions to a certified disposal company. The waste generator is responsible for waste classification and disposal.
DANGER NOTICE:
SIGNAL WORD:
Danger.
STANDARD SAFETY KNOWLEDGE:
May be corrosive to metals. Causes serious eye damage.
SAFE HANDLING GUIDELINES:
Keep out of reach of children. Keep only in the original packaging. Wear protective gloves/protective clothing/goggles/face shield. Dispose of the contents/packaging by handing it over to an authorised person or by taking it to the hazardous waste section of the collection yard.

POISON INFORMATION CENTRE:
Na Bojišti 1, 128 08 Prague 2. Tel.: +420 224 919 293, +420 224 915 402 (24 hours/day)