Thermofol H6 installation set 10 m2, 1500 W

9,023,-

Thermofol H6 installation set 10 m2, 1500 W

The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and ensures the pleasant feeling of a warm floor, which also increases the comfort of any interior. A constant output of 150W/m² ensures optimal thermal parameters, and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The ready-made H6 installation set is prepared for DIY installation.

Termofol H6 Heating Mat Installation Set 0.5m², 75W

Key Features of the Termofol H6 Heating Mat Installation Set, 10m², 1,500W

  • Designed for interior underfloor heating
  • Suitable as both primary and supplementary heating
  • Heats the floor quickly
  • Independent of the central heating system
  • Can be controlled separately
  • Installation without raising the floor height
  • Construction with wires on a fibreglass mesh
  • Suitable for various types of floor coverings
  • Can be installed as a DIY project

Application of the heating mat:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles/parquet/stone

Construction readiness and assembly:
The first step to laying the mat is to create an opening in the wall for two pipes to house the end of the power cable and the sensor wire. A flush-mounted box (Ø 60) must also be placed in the wall for the installation of the temperature controller. Then you can proceed with laying the system on the floor. For the underfloor heating mat to fulfil its purpose, it must be laid evenly over the entire floor area. It is particularly important to maintain equal spacing and to avoid downpipes, sewer drains, hot water installation elements or heating pipes. In the event of a malfunction and the need to replace these elements in the future, the wires could be mechanically damaged. The heating mat should not be laid in such a way that it passes between separate rooms, nor under permanently installed furniture or equipment. However, it is permissible to lay it under wall-hung sanitary ware or furniture on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta or floor covering is too long and does not fit in the room, cuts may only be made in the mesh.

Specifications

Location

Location Pavement

Features

Cable type Two-wire
Heating power 1,500 W
Max. heating mat temperature 70 °C
Mat properties Self-adhesive surface
IP Code IPx7

Dimensions and weight

Width 50 cm
Flat 10 m2
Heating wire thickness 3.6 mm
Code:  TERMtoHO003
Warranty: 24 months