Thermofol H6 installation set 9 m2, 1350 W

8,137,-

Thermofol H6 installation set 9 m2, 1350 W

The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and provides the pleasant feeling of a warm floor, which also increases the comfort of any interior. A constant output of 150W/m² ensures optimal thermal parameters, and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The complete H6 installation kit is ready for DIY installation.

Termofol H6 Underfloor Heating Mat Installation Kit 0.5m², 75W

Key Features of the Termofol H6 Underfloor Heating Mat Installation Kit, 9m², 1350W

  • Designed for interior underfloor heating
  • Suitable as both primary and supplementary heating
  • Heats the floor quickly
  • Independent of the central heating system
  • Can be controlled separately
  • Installation without raising the floor height
  • Construction with wires on a fibreglass mesh
  • Suitable for various types of floor coverings
  • Can be installed as a DIY project

Application of the heating mat:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles / parquet / stone

Site readiness and installation:
The first step in laying the mat is to create an opening in the wall for two pipes to house the end of the power cable and the sensor wire. It is also necessary to place a Ø 60 flush-mounted box in the wall for the installation of the temperature controller. You can then proceed to lay the system on the floor. For the underfloor heating mat to fulfil its purpose, it must be spread evenly over the entire floor area. It is particularly important to maintain the same spacing and to avoid downpipes, sewer drains, hot water installation elements or heating pipes. In the event of a failure and the need to replace these elements in the future, mechanical damage to the wires could occur. It is not advisable to lay the heating mat so that it runs between separate rooms, nor under permanently installed furniture or equipment. On the other hand, it is permissible to lay it under wall-hung sanitary ware or furniture on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta or floor covering is too long and does not fit in the room, only cuts to the mesh may be made.

Specifications

Location

Location Pavement

Features

Cable type Two-wire
Heating power 1,350 W
Max. heating mat temperature 70 °C
Mat properties Self-adhesive surface
IP Code IPx7

Dimensions and weight

Width 50 cm
Flat 9 m2
Heating wire thickness 3.6 mm
Code:  TERMtoHO018
Warranty: 24 months