Thermofol H6-Wifi installation set 4 m2, 600 W

6,115,-

Thermofol H6-Wifi installation set 4 m2, 600 W

The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and provides the pleasant feeling of a warm floor, which also increases the comfort of using any interior. A constant power output of 150W/m² ensures optimal thermal parameters and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The ready-to-use H6-Wifi installation kit is ready for DIY installation.

Termofol H6-Wifi Installation Kit 0.5m², 75W

Key Features of the Termofol H6-Wifi Heating Mat Installation Kit, 4m², 600W

  • Designed for indoor underfloor heating
  • Suitable as both primary and supplementary heating
  • Heats up the floor quickly
  • Independent of the central heating system
  • Can be controlled separately
  • Installation does not raise the floor height
  • Construction with wires on a fibreglass mesh
  • Suitable for various types of floor coverings
  • Can be installed as a DIY project
  • Termofol TF-H6-Wifi thermostat

Heating Mat Application:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles / parquet / stone

Site preparation and installation:
The first step in laying the mat is to create an opening in the wall for 2 pipes to accommodate the power cable end and the sensor wire. A flush-mounted box (Ø 60) must also be placed in the wall for the installation of the temperature controller. Then you can proceed to laying the system on the floor. For the underfloor heating mat to fulfil its purpose, it must be laid evenly over the entire floor area. It is particularly important to maintain the same spacing and to avoid downpipes, drainpipes, hot water installation elements or heating pipes. If these elements fail and need to be replaced in the future, the wires could be mechanically damaged. The heating mat should not be laid so that it passes between separate rooms, nor under permanently installed furniture or equipment. On the other hand, it is permissible to lay it under wall-hung sanitary ware or furniture standing on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta or floor covering is too long and does not fit in the room, only cuts in the mesh may be made.

Specifications

Location

Location Pavement

Features

Cable type Two-wire
Heating power 600 W
Max. heating mat temperature 70 °C
Mat properties Self-adhesive surface
IP Code IPx7

Dimensions and weight

Width 50 cm
Flat 4 m2
Heating wire thickness 3.6 mm
Code:  TERMtoHO031
Warranty: 24 months