Unique and powerful entire outdoor unit
Ubiquiti M5 NanoBridge dual parabolic antenna and electronics emitters placed in the dish.
Dual parabola with a diameter of 42 cm has a gain of 25 dBi (MIMO) for the
5 GHz . Power supply units are designed using 24 V PoE source. The unit is intended mainly for the construction of Point-to-point or as a client station multipointových systems operating in standard 802.11n MIMO TDMA. Achievable real
transfer rate up to 150 Mbps .
For high speed transmission unit
uses standard 802.11n and in the case of use as a client unit also supports AirMAX (TDMA) for connection to the AP with low latency. The antenna system consists of two antennas (MIMO) with horizontal and vertical polarization, which use patented technology InnerFeed to achieve the best performance.
Web administration is very simple and clear. Can be set as:
- AP mode, client or WDS
- Traffic shaping
- QoS
- Between WAN and LAN routing and transparent bridge without NAT/NAT
- The strength of the signal corresponding to the specific signaling LED
In bridge mode and WDS device supports transparent transmission
IPv6 . 24 V PoE power supply includes
the reset button through which you can also bring in NB TFTP firmware recovery mode.
Specifications: Interface: LAN, WiFI
Compliance: FCC, CE
Encryption: WEP, WPA, WPA2
Default password ubnt
Default IP: 192.168.1.20
Default name ubnt
Output to ext. antenna: no
Radiating. angle - H: 8 °/8 °
Radiating. angle - V. 8 °
Gain: 25 dBi
Sensitivity -96 DBm
DHCP: yes
Frequency: 5.4 to 5.825 GHz
Chipset: Atheros
LAN port: 1x RJ45 10/100 Mbps
Max. Output Power: 23 dBm
Modulation: OFDM, QAM
NAND 8 MB
Power supply: 24 V
Standards: 802.11n
Transfer rate: 300 Mbps
Processor: MIPS 24KC, 400 MHz
RAM: 32 megabytes
Operating mode: AP, Client, WDS
Polarization: Linear - horizontal and vertical
Operating temperature: -30 To 75 ° C
Diameter: 420 mm
Weight: 1.5 kg
OS: AirOS V
Support for IPv6: Transparent (bridge mode)