FOLIATEC Spray Film (Dip) 400ml, Colour Copper Metallic

FOLIATEC film is a unique way to easily change the design and protect the original surface . The spray material adheres to almost any smooth surface (only solvent resistance is required), even if it is intricately shaped. After solidification (in just 30 minutes), it will make a metallic copper foil, which perfectly insulates from rain, salt and protects against abrasions from flying stones. If the film is already damaged or you want to change it, it can be easily peeled off without leaving permanent marks after application.

Key properties of copper metallic foil in spray FOLIATEC 400 ml

• Foils for surface protection and design change
• On almost any, even intricately shaped surface (solvent resistance required)
• Water resistant during routine maintenance
• Peeling off the old foil and returning to the original surface
• Easy spray application

Simplified instructions for use (complete instructions can be found in the package)
Basic instructions:
- work at a temperature of 15 - 25 ° C
- Do not apply in direct sunlight or in unventilated areas
- Only apply the film to solvent-resistant surfaces

Pracovní postup:

1. Preparation - remove the wheel from the car (the tire remains on the wheel).
2. Cleaning - clean, dry and thoroughly degrease the surface to be painted with a suitable degreaser.
3. Camouflage - cover the inside of the wheels with a suitable foil, paper or masking tape (3M masking tape is recommended), as well as cover the tire.
4. Painting:

• shake the container properly before use (shake the container even between painting individual layers)
• start painting by gently dusting the surface without trying to cover the original surface (this first layer will bind other layers)
• between the individual layers, let the surface dry for 10-15 minutes
• as needed, apply 3 to 4 coats until the original surface is completely covered
• the vehicle is able to operate for 30 minutes after spraying the last layer
• the film can be easily removed from the surface after 48 hours at the earliest

Upozornění: In order for the applied surface to be really high quality, it is necessary to spray at least 3 to 4 coats. The amount of sprays needed to spray the appropriate amount depends on the area to be sprayed.