LED CONTROL BOX, 13-pin, 12V

The box connects between the 13-pin socket on the car and the terminal on the trolley if there are LED tail lights on the trolley.
The LED box eliminates the reporting of defective bulbs and adjusts the flashing frequency of the turn signals.

• Cable length between box and socket: 0,5 m
• The length of the cable between the plug and the socket: 2,5 m
• Dimensions of the box: 145x110x40 mm
• The device is fixed to the trailer frame with four screws.

One of the advantages of the increasingly used LED trailer lighting is its very low consumption while maintaining high luminous intensity. Unfortunately, the electronics of some towing vehicles, which also control the correct function of the trailer lighting, are not prepared for such low trailer power consumption and are preset only for much higher current consumption of conventional bulbs. Thanks to their very low power consumption, the trailer's LED lamps are detected as defective bulbs by the towing vehicle and the on-board computer reports an error, possibly disconnecting the power supply to the towing socket. The control unit connected between the towing vehicle and the trailer is designed for these cases. The control unit simulates the load of a normal bulb to the towing vehicle's electronics and the operation of the connected LED flashlight is thus trouble-free. The control unit is then capable of transmitting to the on-board computer of the towing vehicle also any malfunction of the directional LED lamps.