AUCTIONEERS OKC 200

Combined storage heater with a volume of 195 litres designed for wall hanging. It is suitable for hot water preparation in buildings with gas or solid fuel central heating in the winter season and heating with electricity outside the heating season using low electricity tariff (night current). The manufacturer has maintained the same 450 mm anchor bolt spacing throughout the production history, so it is no problem to replace it with an old, retired heater.
Heating options:
Electricity:
Ceramic heating element controlled by an operating thermostat and protected by a safety thermostat (thermal fuse). Temperature range 5-74 degrees Celsius. Connection voltage 1-PE-N/AC 230 V/50 Hz. Electrical protection IP 45 allows the heater to be placed in zone 1 according to ČSN 33 2000-7-701.
Exchanger:
The heater can be connected to an external hot water source with max. temperature of 110 degrees Celsius and pressure of 1 MPa. Depending on the power of the source, it is necessary to match the heater with the appropriate power of the heat exchanger. The exchanger operates in both forced circulation and in a stand-alone system. The heating water control sensor can be placed in a common sump with the wiring sensors.
Information on warranty and claiming defects:

• The device requires professional installation. If the device is not installed by a professional company (after verification with the manufacturer, an invoice from the installer is sufficient), it loses the warranty.
• In the event of a boiler defect, the boiler MUST NOT be taken down, servicing is done onsite.
• In the case of an unjustified claim (even a defect that does not manifest itself), the customer is charged for the trip.

Parameters and specifications:
Volume:
195 l
Maximum operating pressure of the vessel:
0,6 MPa
Tension:
230V
Power consumption:
2200W
Electrical coverage:
IP 45
Heater height:
1300 mm
Heater diameter:
584 mm
Maximum weight of the heater without water:
81 kg
Electric heating time from 10 °C to 60 °C:
5.5 hours
Maximum operating overpressure of the heat exchanger:
1 MPa
Temporal area:
0,68 m2
Nominal heat output at a heating water temperature of 80 °C and a flow rate of 310 l/hr:
9000 W
Exchanger heating time from 10 °C to 60 °C:
86 min
Nominal heat output at a heating water temperature of 80 °C and a flow rate of 720 l/hr:
17000 W
Exchanger heating time from 10 °C to 60 °C:
45 minutes
Thermal losses:
1.4 kWh/24 hours
Energy efficiency class:
B