Marantz PM5005 black

Marantz PM5005 Integrated Amplifier offers an affordable cost a lot of great sound. Powered by current feedback, which until recently was reserved for higher class models. With it provides a very fast and accurate signal processing, which results in perfectly balanced stereo reproduction and a very open, its spatial location.

Marantz PM5005 can deliver output 40 watts per channel into eight ohms or 55 watts at four. Is stored in a metal chassis with rugged front panel , Which further enhances the solidity of its construction. The amplifier is fitted with a custom-optimized components for sound tuning, phono preamp, or even bypass function Signal Processing (Source Direct), which shortens the signal paths to a minimum. With all these elements raises the bar recitation amplifiers basic class are a bit higher.

Current feedback

Current Feedback Technology implements reproduction with a wide frequency range and its response. Impedance in point current feedback is limited, which is reflected in very low phase shift. By keeping the negative feedback (NFB) to a minimum is effectively improved transient response. With this is achieved high readability recitation over the entire frequency range. When amplification with current feedback is not unlike classical gain with voltage feedback amplifier power sensitive high dynamic volume.

Source Direct

Source Direct mode provides the highest possible purity. When activated, the signal passes through the shortest possible route avoiding the processing circuit tone, which is especially important for audiophile recordings, where users prefer closest reproduction in relation to the original recording.

Specifications:

Sound characteristics:
Output power (4.8 ohm): 40/55 W RMS, 45/60 W DIN, 55/80 W IHF
Frequency response: 10 Hz - 50 kHz
Total harmonic distortion: 0.05%
Damping factor: 100
MM Input sensitivity: 2 mV/47 kOhm
Signal-to-Noise Ratio MM: 83 db
Input sensitivity - line input: 200 mV/20 kOhm
Signal-to-Noise Ratio - Line Input: 102 db

Connectors:
6x analog audio input (including 1x phono (MM))
2x analog audio output
1x D-Bus
1x headphone output
Output for two pairs of speakers (A/B, screw terminals)

Other:
Power supply with linear excitation/Source Direct function/standby/Current Feedback Topology (current feedback)/phono preamp/version HDAM SA3, SA2/audio components of high quality/symmetry/Bass/Treble/Loudness function

Power:
Operating Power Consumption: 110 W
Standby power consumption: 0.3 W
Auto power off

Design:
Color: Black
The metal front panel
Dimensions: 440 x 370 x 105 mm (W x H x V)
Weight: 6.7 kg

Standard accessories:
System remote control (can also be used to control other Marantz components)