Thermofol H6 installation set 3,5 m2, 525 W

5,042,-

Thermofol H6 installation set 3,5 m2, 525 W

The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and provides a pleasant feeling of a warm floor, which also increases the comfort of any interior. A constant output of 150W/m² ensures optimal thermal parameters and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The ready-to-use H6 installation kit is prepared for self-installation.

Termofol H6 Heating Mat Installation Kit 0.5m², 75W

Key Features of the Termofol H6 Heating Mat Installation Kit, 3.5m², 525W

  • Designed for interior underfloor heating
  • Suitable as both primary and supplementary heating
  • Fast floor heating
  • Independent of the central heating system
  • Can be controlled separately
  • Installation without raising the floor height
  • Construction with wires on a fibreglass mesh
  • Suitable for various types of floor coverings
  • Can be installed by yourself

Heating mat application:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles / parquet / stone

Structural readiness and assembly:
The first step to laying the mat is to create an opening in the wall for 2 pipes to house the power cable end and the sensor wire. A Ø60 flush-mounted box must also be placed in the wall for the installation of the temperature controller. You can then proceed to lay the system on the floor. In order for the underfloor heating mat to serve its purpose, it must be spread evenly over the entire floor area. It is particularly important to maintain equal spacing and to avoid downpipes, sewer drains, hot water installation elements or heating pipes. In the event of a failure and the need to replace these elements in the future, mechanical damage to the wires could occur. It is not advisable to lay the heating mat so that it runs between separate rooms, or under permanently installed furniture or equipment. However, it is permissible to lay it under wall-hung sanitary ware or furniture standing on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta or floor covering is too long and does not fit in the room, only cuts in the mesh may be made.

Specifications

Location

Location Pavement

Features

Cable type Two-wire
Heating power 525 W
Max. heating mat temperature 70 °C
Mat properties Self-adhesive surface
IP Code IPx7

Dimensions and weight

Width 50 cm
Flat 3.5 m2
Heating wire thickness 3.6 mm
Code:  TERMtoHO010
Warranty: 24 months