Thermofol H6 installation set 15 m2, 2250 W

12,121,-

Thermofol H6 installation set 15 m2, 2250 W

The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and provides the pleasant feeling of a warm floor, which also increases the comfort of any interior. A constant output of 150W/m² ensures optimal thermal parameters and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The ready-made H6 installation kit is prepared for self-installation.

Termofol H6 Heating Mat Installation Kit 0.5 m2, 75 W

Key features of the Termofol H6 heating mat installation kit, 15 m², 2250W

  • Designed for indoor underfloor heating
  • Suitable for both primary and supplementary heating
  • Fast floor heating
  • Independent of the central heating system
  • Can be controlled separately
  • Installation without raising the floor height
  • Construction with wires on a fibreglass mesh
  • Suitable for various types of floor coverings
  • Can be installed yourself

Application of the heating mat:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles / parquet / stone

Structural readiness and assembly:
The first step to laying the mat is to create a hole in the wall for 2 pipes to accommodate the end of the power cable and the sensor wire. A Ø 60 flush-mounted box must also be placed in the wall for the installation of the temperature controller. Then you can proceed with laying the system on the floor. For the underfloor heating mat to fulfil its purpose, it must be spread evenly over the entire floor area. It is particularly important to maintain the same spacing and avoid downpipes, sewer drains, hot water installation elements or heating pipes. In the event of a failure and the need to replace these elements in the future, the wires could be mechanically damaged. It is not advisable to lay the heating mat so that it passes between separate rooms or under permanently installed furniture or equipment. On the other hand, it is permissible to lay it under wall-hung sanitary ware or furniture standing on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta or floor covering is too long and does not fit in the room, only cuts in the mesh may be made.

Specifications

Location

Location Pavement

Features

Cable type Two-wire
Heating power 2,250 W
Max. heating mat temperature 70 °C
Mat properties Self-adhesive surface
IP Code IPx7

Dimensions and weight

Width 50 cm
Flat 15 m2
Heating wire thickness 3.6 mm
Code:  TERMtoHO005
Warranty: 24 months