Thermofol H6-Wifi installation set 4,5 m2, 675 W

6,388,-

Thermofol H6-Wifi installation set 4,5 m2, 675 W

The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and provides the pleasant feeling of a warm floor, which also increases the comfort of any interior. A constant output of 150W/m² ensures optimal thermal parameters, and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The ready-made H6-Wifi installation set is prepared for DIY installation.

Termofol H6-Wifi Installation Set Heating Mat 0.5m², 75W

Key Features of the Termofol H6-Wifi Heating Mat Installation Set, 4.5m², 675W

  • Designed for interior underfloor heating
  • Suitable as both primary and supplementary heating
  • Fast floor heating
  • Independent of the central heating system
  • Can be controlled separately
  • Installation without raising the floor height
  • Construction with wires on a fibreglass mesh
  • Suitable for various types of flooring
  • Can be installed DIY
  • Termofol TF-H6-Wifi thermostat

Application of the heating mat:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles / parquet / stone

Structural preparation and installation:
The first step to laying the mat is to create an opening in the wall for two pipes, into which the end of the power cable and the wire with the sensor will be placed. A flush-mounted box (Ø60) must also be placed in the wall to install the temperature controller. Then you can proceed to laying the system on the floor. For the underfloor heating mat to fulfil its purpose, it must be spread evenly over the entire floor area. It is particularly important to maintain the same spacing and avoid downpipes, sewer drains, hot water installation elements, or heating pipes. If these elements fail and need to be replaced in the future, the wires could be mechanically damaged. It is not advisable to lay the heating mat so that it passes between separate rooms, nor under permanently installed furniture or equipment. However, it is permissible to lay it under wall-hung sanitary ware or furniture standing on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta, or floor covering is too long and does not fit in the room, cuts may only be made to the mesh.

Specifications

Location

Location Pavement

Features

Cable type Two-wire
Heating power 675 W
Max. heating mat temperature 70 °C
Mat properties Self-adhesive surface
IP Code IPx7

Dimensions and weight

Width 50 cm
Flat 4.5 m2
Heating wire thickness 3.6 mm
Code:  TERMtoHO030
Warranty: 24 months